Logical modules

This is the place to chat if you need any help using BC Modular
Post Reply
User avatar
JoPo
Posts: 167
Joined: Mon Apr 29, 2013 4:43 pm

Logical modules

Post by JoPo » Sun May 12, 2019 11:13 am

Hi !
It's been a wild...

I can't get any result with the 'And' module. Tried to enter the same value on both input, the output remains at 0. I tried also with other value = no luck.

And the 'send value' module either. I entered a value in the panel, then entered negative, positive value at its 'in', it never spited out the value ! Always 0 !

How those modules work ? Thanks for some tips !

Spielraum
Posts: 65
Joined: Sun Apr 20, 2014 3:49 pm

Re: Logical modules

Post by Spielraum » Sun May 12, 2019 10:35 pm

logic theoretically only 0 or 1

AND:
In1+In2=Out
0+0=0
0+1=0
1+1=1
1+0=0

Value Sender:
the In "Val selection+enter" is enough to send Value
In | Val | Out
-2147483648 - 2147483647 "select" | -2147483648 - 2147483647 | -2147483648 - 2147483647

last edit: 14.5.2019, 1:00

User avatar
JoPo
Posts: 167
Joined: Mon Apr 29, 2013 4:43 pm

Re: Logical modules

Post by JoPo » Mon May 13, 2019 12:57 pm

^Thanks ! I know about logical gates ! I'm a teacher for programming industrial automatical huge machines.

It's just that it doesn't seem to work as you described.

The legacy 'gate logic' module works but it spit out the result after 100ms ! Unusable.

Spielraum
Posts: 65
Joined: Sun Apr 20, 2014 3:49 pm

Re: Logical modules

Post by Spielraum » Mon May 13, 2019 11:05 pm

20190513a-BCMv0_98-AND+ValueSender.gif
BCM v0.98b TEST
20190513a-BCMv0_98-AND+ValueSender.gif (128.84 KiB) Viewed 1187 times

Post Reply