Page 1 of 1

Logical modules

Posted: Sun May 12, 2019 11:13 am
by JoPo
Hi !
It's been a wild...

I can't get any result with the 'And' module. Tried to enter the same value on both input, the output remains at 0. I tried also with other value = no luck.

And the 'send value' module either. I entered a value in the panel, then entered negative, positive value at its 'in', it never spited out the value ! Always 0 !

How those modules work ? Thanks for some tips !

Re: Logical modules

Posted: Sun May 12, 2019 10:35 pm
by Spielraum
logic theoretically only 0 or 1

AND:
In1+In2=Out
0+0=0
0+1=0
1+1=1
1+0=0

Value Sender:
the In "Val selection+enter" is enough to send Value
In | Val | Out
-2147483648 - 2147483647 "select" | -2147483648 - 2147483647 | -2147483648 - 2147483647

last edit: 14.5.2019, 1:00

Re: Logical modules

Posted: Mon May 13, 2019 12:57 pm
by JoPo
^Thanks ! I know about logical gates ! I'm a teacher for programming industrial automatical huge machines.

It's just that it doesn't seem to work as you described.

The legacy 'gate logic' module works but it spit out the result after 100ms ! Unusable.

Re: Logical modules

Posted: Mon May 13, 2019 11:05 pm
by Spielraum
20190513a-BCMv0_98-AND+ValueSender.gif
BCM v0.98b TEST
20190513a-BCMv0_98-AND+ValueSender.gif (128.84 KiB) Viewed 234 times